Up Next

My Robot

8 months ago
I made a bboard robot that drives with the controller. 1. I coded the microbit to control the wheel. 2. I created a remote with another microbit using a radio signal. 3. I then created 3d design that the servo wheel would fit in. I had to try a few times. I added some googly eyes for a finishing touch."
Apprendre et créer tout en s'amusant! Cabane lumineuse: fabriquer avec du carton et les outils Makedo. Choisir les dimensions, découper la structure et assembler le tout. Décorer la cabane. Ajouter de la lumière en créant des codes pour les lumières. Jeux de création: il suffit de créer un coin labo créatif et d'y ajouter les activités. La structure doit comprendre un système de rangement efficace et accessible aux élèves.
A solution to providing a thirsty puppy fresh water when she needs it! We used a waterproof container from our recycling bin, a plastic straw, our bboard, microservo and a motion click. We also used our 3D printer to make an L shaped hard surface so that the little servo lever would clamp the straw when no motion was detected. We used the coding software from the Brilliant Labs bboard website to write a code for the microservo that controlled the lever dependent on the information it received from the motion click indicating if Polly was at her dish drinking or not. One issue that we had that we later fixed was the water leakage around the straw. Initially, we used silly puddy that we had at home but we later asked our dad to get us some waterproof caulking to use around the straw as it went into the water reservoir.